PREPARATION FOR INSTALLATION
The vehicle surface and the brown magnetic side of the sign should be clean, dry and waxed prior to application.
 

INSTALLATION
Make contact of one edge of the sign to the vehicle surface in the desired location, and then let the adjacent part of the sign contact the vehicle surface, until the entire sign is held magnetically to the vehicle.  If the sign is not in the desired position, remove it and repeat the steps above. (Do not try to straighten the sign by pulling on it when it is held magnetically to the vehicle.  Doing so may stretch the sign, especially when hot.)

Avoid placing your sign over chrome trim or surface protrusions of any kind.

The temperature of the sign should be at least 60 degrees F during installation.  (The temperature of the vehicle surface does not matter.)

CAUTION
Magnetic vehicle signs will NOT adhere to areas on your car where plastic body fillers have been used.  Use caution in applying vehicle signs to areas of your car that have been damaged and repaired, in order to avoid losing your signs.  Make sure the entire magnet is against the metal surface (no air pockets).
 

CLEANING
Clean your sign with plain water or warm water and a mild detergent and a soft cloth.

WARNING
Trapped moisture, dirt or chemicals may harm your vehicle's finish.  To protect the new, clear coat/base coat and vinyl surfaces present on some new vehicles, it is recommended the signs be removed daily and both the signs and vehicle be cleaned and dried.  Pay close attention, especially for the first 90 days of use, for any changes in your vehicle finish.  A generous waxing of both the surface where the signs will be placed and the backs of the signs themselves will help prevent damage.

STORAGE
To avoid cracking or breaking, do not fold or crease your vehicle magnets.  Storing your magnetic signs flat is recommended.  If stored in roll form, the roll must be a minimum of 3" in diameter, with the lettering facing the outside of the roll to prevent wrinkles.